High degree of protection Waterproof membrane Easy to install Pressure differentials in enclosures with a high degree of protection are a result of internal and external temperature changes. In the case of negative pressure or partical vacuum, dust and humidity can enter the enclosure through the door seal. When the air inside the enclosure cools down, condensation may occur because the humidity cannot escape the enclosure. The easy-to-install pressure compensation device DA 284 provides compensation of pressure at a protection degree of IP66. Even with a slight overpressure, a waterproof membrane inside the plug allows the humidity to escape whilst blocking water and dirt from entering the enclosure
Pressure compensation Device DA 284
High degree of protection Waterproof membrane Easy to install Pressure differentials in enclosures with a high degree of protection are a result of internal and external temperature changes. In the case of negative pressure or partical vacuum, dust and humidity can enter the enclosure through the door seal. When the air inside the enclosure cools down, condensation may occur because the humidity cannot escape the enclosure. The easy-to-install pressure compensation device DA 284 provides compensation of pressure at a protection degree of IP66. Even with a slight overpressure, a waterproof membrane inside the plug allows the humidity to escape whilst blocking water and dirt from entering the enclosure
Technical Data
Mounting
thread M40 x 1.5 with nut
Torque
5Nm (max. 10Nm)
Depth in enclosure
approx. 9mm
Material
stainless steel V2A (DIN 1.4305 / AISI 303)
Sealing
sealing gasket NBR
Filter
waterproof membrane
Air permeability
1200l/h at a pressure difference of min. 70mbar
Dimensions
Ø 58 x 31mm
Fitting position
variable
Operating / Storage temperature
-45 to +80°C (-49 to +176°F)
Installation Make cut-out Ø 40.5 +0.5mm in enclosure wall and mount pressure compensation device with nut. Please make sure that the sealing gasket is put in place on the outer side panel of the enclosure. For optimal pressure compensation we recommend to use two devices on opposite sides towards the top of the enclosure.
Art. No.
Protection type
Packaging unit
Weight (approx.)
28401.0-00
IP66 (EN 60529) / IPX9K (EN 40050-9)
1 piece
160g
Technical Data
Mounting
thread M40 x 1.5 with nut
Torque
5Nm (max. 10Nm)
Depth in enclosure
approx. 9mm
Material
stainless steel V2A (DIN 1.4305 / AISI 303)
Sealing
sealing gasket NBR
Filter
waterproof membrane
Air permeability
1200l/h at a pressure difference of min. 70mbar
Dimensions
Ø 58 x 31mm
Fitting position
variable
Operating / Storage temperature
-45 to +80°C (-49 to +176°F)
Installation Make cut-out Ø 40.5 +0.5mm in enclosure wall and mount pressure compensation device with nut. Please make sure that the sealing gasket is put in place on the outer side panel of the enclosure. For optimal pressure compensation we recommend to use two devices on opposite sides towards the top of the enclosure.
